In a nukr series stud type track rollers, Pressed Steel Cage is the cage, which spaces the rolling elements and keeps them from touching each other. The grade is low-carbon sheet steel, two-piece riveted or ribbon type, rolling-element guided; it is magnetic, and its usable service range is not the limiting element; the lubricant and the ring heat stabilization decide. This page covers what the material changes about the bearing, the limits it brings with it, and the sizes supplied.
Why Pressed Steel Cage for NUKR Series Stud Type Track Rollers
The standard cage of volume bearing production: light, cheap, tolerant of temperature and unaffected by the oils that age a polymer cage. In a nukr series stud type track rollers it is the cage, which spaces the rolling elements and keeps them from touching each other.
Pressed from sheet and guided by the rolling elements, it adds almost no mass and almost no cost, tolerates a wide temperature range, and is unaffected by lubricant chemistry. It is the default cage of the standard bearing ranges for good reasons.
Material Properties
| Grade designation | low-carbon sheet steel, two-piece riveted or ribbon type, rolling-element guided |
|---|---|
| Magnetic response | Magnetic |
| Service temperature | Not the limiting element; the lubricant and the ring heat stabilization decide |
| Corrosion characteristic | As the rings — it relies on the lubricant and the seals |
Alternatives and When to Switch
Polyamide where quiet running and low friction matter and the temperature is moderate; machined brass where speed, shock or lubricant chemistry rules both of the others out.
What the Material Changes About the Bearing
The cage carries no load, so it changes no rating. What it changes is the operating envelope: the maximum temperature, the maximum speed, the tolerance of shock and vibration, the noise, and the compatibility with the lubricant. A bearing is very often limited by its cage long before its rings are in any danger, which is why the cage suffix in a designation is not a detail.
Sizes of NUKR Series Stud Type Track Rollers Available in Pressed Steel Cage
| Designation | Roller outer diameter D (mm) | Roller width C (mm) |
|---|---|---|
| NUKR35 | 35 | 18 |
| NUKR40 | 40 | 18 |
| NUKR47 | 47 | 24 |
| NUKR52 | 52 | 24 |
| NUKR62 | 62 | 29 |
| NUKR72 | 72 | 29 |
| NUKR80 | 80 | 35 |
| NUKR85 | 85 | 35 |
| NUKR90 | 90 | 35 |
