Polyamide Cage is the cage, which spaces the rolling elements and keeps them from touching each other — light, quiet and low friction, and it survives momentary misalignment and starved starts better than a steel cage; it is also the reason a polyamide-caged bearing cannot be run to the temperature limit of its own rings. On a uc300 series insert bearings that matters because unaffected by ordinary mineral greases and oils; aged prematurely by some synthetic oils and by aggressive EP additives at temperature. The property data, the comparison against the alternatives and the size table are below.
Why Polyamide Cage for UC300 Series Insert Bearings
Light, quiet and low friction, and it survives momentary misalignment and starved starts better than a steel cage; it is also the reason a polyamide-caged bearing cannot be run to the temperature limit of its own rings. In a uc300 series insert bearings it is the cage, which spaces the rolling elements and keeps them from touching each other.
A moulded polyamide cage is light, quiet and forgiving: it runs with less friction than a steel cage, tolerates momentary misalignment and shock, and survives a starved start that would let a steel cage wear. Its price is a temperature ceiling well below the rings'.
Material Properties
| Grade designation | glass-fiber reinforced PA66, injection molded as a one-piece snap cage (suffix TVP / TVH depending on the maker) |
|---|---|
| Magnetic response | Non-magnetic |
| Service temperature | Continuous service to about +120 °C — above that the polyamide ages rapidly, and it is the cage rather than the steel that ends the bearing |
| Corrosion characteristic | Unaffected by ordinary mineral greases and oils; aged prematurely by some synthetic oils and by aggressive EP additives at temperature |
Service Limits
Temperature is the limit, and it is a limit on the BEARING, not just on the cage: about +120 °C continuous, with the polyamide aging rapidly above that, especially in the presence of an oil with aggressive EP additives. A bearing that runs at 130 °C should not be ordered with a polyamide cage even though its rings would be perfectly content there.
Alternatives and When to Switch
Pressed steel is the alternative for ordinary duty at temperature; machined brass for high speed, heavy shock, and for lubricants that would age a polymer cage.
Sizes of UC300 Series Insert Bearings Available in Polyamide Cage
| Designation | Bore d (mm) | Outer diameter D (mm) | Width B (mm) |
|---|---|---|---|
| UC305 | 25 | 62 | 38.1 |
| UC306 | 30 | 72 | 42.9 |
| UC307 | 35 | 80 | 48.4 |
| UC308 | 40 | 90 | 52.4 |
| UC309 | 45 | 100 | 55.6 |
| UC310 | 50 | 110 | 65.1 |
| UC311 | 55 | 120 | 65.1 |
| UC312 | 60 | 130 | 77.8 |
| UC313 | 65 | 140 | 77.8 |
| UC314 | 70 | 150 | 82.6 |
| UC315 | 75 | 160 | 82.6 |
